Terma Forte 2939 BTU White Single Panel Radiator 600 x 1254mm

Forte is a flat bar range of designer radiators available in both single or double panel variants; each bar is 70mm wide with a small gap which creates a very seamless looking design set against the wall. The Forte single panel (V10) model is manufactured from a single layer of flat steel profiles mounted on round rear collectors, with a very shallow projection of just 73 mm including fixings, meaning this model is well suited to spaces where the overall projection is limited. Note: Terma also offer a Forte double panel (V20) model which has a deeper projection of 93mm. This white (RAL 9016) colour has a silk, smooth texture. Terma offers a 150x50mm colour chip of this finish should you wish to see the colour prior to purchase. The Forte range have the unique feature that they can be installed either... vertically with the bars running up and down (valves connected on the sides)... or they can be installed horizontally with the bars running left to right (valves connected on the undersides). The same physical model you buy can be installed either way up giving maximum flexibility dependant on your space requirements. See the images for how the radiators look each way up as they can give a very different looking design as you rotate each model and we show images of these fitted both ways for every size. Forte is supplied with a universal bracket which allows the radiator to be installed either way up, full instructions supplied. As you rotate the radiator either way up it changes the view you will have of the brackets from the side of the radiator. With the bars running vertically the brackets are on show, but with the bars running horizontally the brackets are fully concealed from view. See the images for this difference. Forte is pre fitted with an internal diverter (baffle) which is a barrier to aid the flow of water up and over inside the radiator to ensure even heat distribution across all bars. If being installed with the bars running vertically this should be left in place. If this is installed with the bars running horizontally this need to be tapped out (full instructions supplied for the plumber).