Enhance slip resistance on wet floor surfaces with the StoneCare4U Essential Slip-Stop 5L. Suitable for use on ceramic, porcelain, and natural stone floors and showers, effectively improving slip resistance on wet floors for long-lasting protection against slip and fall accidents. It is important to note that this product is not suitable for vinyl, linoleum, wood, metal, or coated surfaces. How to apply: First, remove any loose debris from the work surface and ensure you have adequate safety wear, i.e. gloves, suitable protective eyewear, face mask and clothing. A small test application in an inconspicuous area before use is recommended. This will indicate the suitability and effectiveness of the product for your surface. Importantly, ensure the surface is free from dirt, grease and oil before starting. Essential Slip-Stop needs to be applied in small sections. A mop, sponge or dry cloth is most commonly used. The wet surface must be agitated with a stiff brush and left to stand for 3 to 10 minutes. Most importantly, Don not let the product dry on the surface. Subsequently, rinse clean with water when each area is completed and move on to the next area to be treated. Maximum slip resistance is attained within 3 to 10 minutes. This time will depend on how hard the surface material is. Bear in mind that you can always reapply if necessary. Dwell time: 3 to 10 minutes for ceramic or porcelain tiles, shower trays and baths. Dwell time: 5 to 10 mins for natural stone and masonry. Indeed, a test patch must be completed before use to determine the dwell time required, as the above times can only be a guide.