Don't let fading block you down. Seal it with the StoneCare4U Essential Satin Finish Block Paving Sealer. Suitable for outdoor natural stone such as block pavers, it seals and protects and adds a satin look to the stone surface. It is a high-performance stone sealer formulated for external paved surfaces, including natural clay and engineered concrete types. Also suitable for other porous natural stones such as sandstone, limestone and slate. It provides a hard-wearing, attractive satin finish that can intensify natural colours and offers high-quality stain protection. It can also be applied to internal surfaces. The safe, VOC-free, eco-friendly H2O formula is quick-drying and easy to apply. How To Apply: Before use, remove any loose debris from the work surface and ensure adequate safety wear, i.e. gloves, suitable protective eyewear, face mask and clothing. Note: Following the instructions below, perform a small test application in an inconspicuous area before use. This will indicate the suitability and effectiveness of the product for your surface. If unsuitable for your requirements, do not proceed. Application temperature range: 13° to 23°C. Before application, the surface must be clean and dry, plus ensure favourable weather conditions before commencing. Apply the sealer thinly and evenly with a low-pressure sprayer, micro-fibre mop, paintbrush or soft cloth. Take care not to leave application marks or allow the product to puddle on the surface. Allow 45 to 60 minutes drying time before applying the second coat, repeating the same process and applying the product in the opposite direction to help achieve an even consistent finish. If necessary, more coats can be applied to achieve the desired finish. Please Note: Do not dilute. It is likely to change the colour or appearance of some surfaces – always try the product in an inconspicuous area before use. Surfaces that are not to be sealed should be protected with masking material. It is not recommended for use on highly polished stone and ceramic glazed surfaces. Maintenance: Clean sealed areas with a mild, pH-neutral cleaner or a very low concentration of the outdoor cleaner. Do not use harsh or abrasive cleaning agents as this can hurt the treated surface. Coverage: Apply undiluted, up to 15m² per litre per coat. Coverage will vary depending on the type of surface application. Quantity: 5L. Pack of three.