Get that plumbing job done in no time with our quality plumbing products. Essential for both DIY and professional plumbers, the compression tee is ideal for joining branched pipes without using heat or soldering. Use the compression equal tee to branch off a supply pipe. The compression equal tee is resistant to corrosion. It is easy to fit. Size: 22mm. How to make a compression joint: Isolate the water. Pipe ends must be cut square and deburred. Remove nut (A) and olive (B) from fitting (C) if present. Jointing paste or PTFE tape may be applied to the threads. Slip nut (A) and olive (B) onto the pipe. Push the pipe into the fitting body until it goes no further. Slide nut (A) and olive (B) on the pipe onto the fitting and tighten the nut by hand. Hold fitting in one spanner and tighten nut half to one full turn with another spanner. Do not over-tighten. Repeat steps 3 to 9 for other ends if applicable. Turn on the water and check all joints are watertight.